Akta fraction collector manual

Fraction collector F9-C and Fraction collector F9-R are automated fraction collectors intended for the collection of fractions from purification runs. Fraction collector F9-C and Fraction collector F9-R are intended for research use only, and shall not be used in clinical procedures, or for diagnostic purposes. u. In the manual control panel for the pumps, move the slider to a flow rate of 1 ml/min and click ‘Set flow rate’. Pump A will begin to move the mobile phase at that rate through the injection valve, the ‘column’, detectors (uv, conductivity and/or pH) and on to the waste receptacle (or fraction collector if specified). ÄKTA start can be equipped with Frac30, a round fraction collector (Fig 6) that is controlled through either the ÄKTA start touchscreen display or through UNICORN start. Frac30 allows you to collect up to 30 fractions and supports four tube sizes, ranging from to 15 ml. Fractions can be automatically collected in volumes ranging from to 15 ml.

ÄKTA pure can be equipped with up to two fraction collectors, two units of fraction collector F9-R or one F9-R and one F9-C. ÄKTA go can be used with one fraction collector F9-R. ÄKTA avant can use one fraction collector F9-R as a second fraction collector in addition the build-in fraction collector. See Section Clean Fraction collector F9-C in the ÄKTA pure System Handbook. Use the Fraction collector cleaning position. Too high flow rate during usage of Drop sync. Use a flow rate below 2 ml/min. One or more Cassettes have empty positions. Make sure that all Cassette positions contain tubes or plates. The tubes are flooded. Fraction collector F9-C and Fraction collector F9-R are automated fraction collectors intended for the collection of fractions from purification runs. Fraction collector F9-C and Fraction collector F9-R are intended for research use only, and shall not be used in clinical procedures, or for diagnostic purposes. u.

ÄKTA™ go is a small and compact liquid chromatography system Only one fraction collector may be used at the same time. A Inlet valve (V9-ImA). ÄKTAprime plus User Manual Edition AA. Checking the fraction collector. Checking tube shifts. 1. Select menu Check and press OK. This manual describes the operation of the ÄKTA™FPLC™ system. installation and operation of the fraction collector. It also includes.